Genuine Mitto RCB02
Programming of your new Remote control
Receiver with Digital screen
- Press the “OK” button on your receiver twice. The screen displays “PARA”.
- Press the “-” button on your receiver twice. The screen displays “RADIO”.
- Press the “OK” button on your receiver once. The screen displays “ADJ STRT”.
- Press the “OK” button on your receiver once. The screen displays “Hide Button”.
- Press both buttons on your new remote control at the same time. Keep them pressed down. The screen displays “Released”.
- Let the buttons go. The screen displays “Desired Button”.
- Press a button on your new remote control. The screen displays “OK”.
- Wait 10 seconds.
- Your new remote control is programmed.
Programming of your new Remote control
Receiver without Digital screen
- Open the casing of your receiver. It is located next to your motor.
- On the receiver circuit board, press the programming button (SW1). The LED light of the receiver blinks. Let the button go.
- Press both buttons on your new remote control at the same time. Let them go. The LED light of the receiver remains lit fixedly.
- Press the left button on your new remote control. Let it go. The LED light of the receiver blinks.
- Wait 5 seconds. The LED light of the receiver turns off.
- Repeat this procedure for the right button of your new remote control. This time, use the programming button SW2.
- Wait 10 seconds.
- Your new remote control is programmed.
Coding via existing coded remote
Locate a remote already coded to & working the device. Be within 3 meters of the gate control box.
Original Remote: Press hidden button on back of remote with a pin or paper clip OR press Button 1 & 2 together until remote LED lights.
Original Remote: Momentarily press button that opens device.
This puts the device receiver into learning Mode
New Remote: Press hidden button on back of remote with a pin or paper-clip or press buttons 1 & 2 together until remote LED lights.
This teaches the receiver the additional code to remember.