FAAC XKP W Wireless Keypad Coding Instruction

 

Programming

The programming function is PWD protected. In order to restrict access, set a new PWD when the system is programmed for the first time. Do not give the PWD to other people.
Factory-set PWD: 1 2 3 4
When the XKP W is waiting for an operation, enter: # PWD # then choose the option 1-12 from the menu and carry out the procedure following the instructions.
E.g: for a new user code, enter: 1 # (look for the instructions 1)

Menu
1 Store a user code
2 Delete a user code
3 Delete all user code
4 Change the PWD
5 Restore factory settings

If the XKP W indicates an ERROR (beeping 5x with red LED fast flashing), it should be reprogrammed correctly. After the OK (beeping once with green LED on for 0.5 s) message appears, the XKP W waits for an operation for 60 s.
When the XKP W is waiting for an operation, it is possible to carry out another operation from the menu. Press E to end the programming (it will also end when no key being pressed after time out).

 

1. STORE A USER CODE

This stores the user codes that must be entered to activate the radio channels. You can choose Easy or Advanced mode of operation. Only number codes can be entered. If you attempt to store a code that is already in memory, the XKP W signals an error.


• Easy operation

User codes consisting of 4 numbers, in various combinations. Each code can be enabled for only 1 radio channel, to be specified when it is being stored.
When the XKP W is waiting for an operation, enter:
1 # code # code E Ch #

• Advanced operation

User codes of variable length from 2 to 6 digits, in various combinations. Each code can be enabled for 1, several or all of the radio channels available.
When the XKP W is waiting for an operation, enter:
1 # code # code # (enables all channels)
1 # code # code E Ch # (enables only 1 channels)
1 # code # code E Ch Ch …# (enables several channels)

 

2. DELETE A USER CODE

When the XKP W is waiting for an operation, enter:
2 # code # code #

 

3. DELETE ALL USER CODE

When the XKP W is waiting for an operation, enter:
3 # 3 #

 

4. CHANGE THE PWD

Enter the PWD (maximum of 6 digits). Only numeric codes can be entered.
When the XKP W is waiting for an operation, enter:
4 # new PWD # new PWD #

 

5. RESTORE FACTORY SETTINGS

This restores the XKP W to its factory settings: user code memory empty, direct radio channel (button E) disabled, Easy Operation, PWD: 1 2 3 4, randomized radio codes. When finished, the XKP W exits from programming mode and goes into standby.
When the XKP W is waiting for an operation, enter:
5 # 5 #

M