ATA – ESV24MS manual
Product Description
The Automatic Technology EasySlider® sliding gate opener kit consists of one (1) drive unit with integrated controller, two (2) handheld PTX-4 SecuraCode® transmitters, a pre-wired antenna ready for mounting on the fence-line and two (2) limits actuators. (Fig. 01).
Integrated controller
The integrated controller is able to control a single or dual leaf gate. An outdoor type 240V AC power outlet is required to power the system.
Mechanical drive unit
The drive unit consists of a powerful 24V DC motor, rugged gearbox and limits assembly combined with a key lockable manual release lever. When installed with suitable cable glands the EasySlider® meets the IP33 standard for preventing ingress of dust and water.
Drive Unit Installation
The Automatic Technology EasySlider® sliding gate opener is designed to operate most residential sliding gates. The gates must be in good working condition and should operate freely by hand.
Initial checking
Before commencing installation of the EasySlider®, check the following:
- The gate moves freely and easily by hand for the full opening and closing travel.
- The mounting point must be solidy constructed, e.g concrete, brick or steel, and must be capable of withstanding the full force applied to the gate.
- Select a suitable location for mounting the drive unit. This position is usually established by fully opening the gate fully and mounting the drive unit within a suitable distance of the gate edge.
- A weather-proof 240 v 10 amp power outlet must be located within one (1) metre of the EasySlider® mounting point.
- If P.E. beams are to be installed provision for underground cabling should be made from one side of the gateway to the other.
