ATA GDO 11v1 Installation Sheet lores

Coding Transmitters

Remotely Coding Transmitters
Using this method transmitters can be coded without access to the opener’s control panel as long as a pre-coded transmitter is available.

NOTE: The door or courtesy light must activate when the steps below are performed. This indicates that the pre-coded transmitter is in range of the opener, and the correct button has been pressed.
a. Take any pre-coded transmitter. Press the button for the function to be duplicated and release.
b. Using a small needle / pen, press and hold firmly for two seconds the middle button, through the Coding Hole.
c. Within 10 seconds take the additional transmitter you wish to code. Hold the new transmitter’s button for two seconds, pause for two seconds, hold again for two seconds and then release.
d. Wait for 10 seconds and then press the new transmitter’s button to test.

Coding a Transmitter Button to Enable Vacation Mode
The opener can be programmed into a “Vacation Mode” where the opener will not respond to any transmitter except the button of the transmitter that was programmed for vacation mode.

a. Briefly press the DOOR CODE button once, then press it again and hold (will beep two times on second press).
b. Press one of the four (4) buttons on the transmitter for two (2) seconds, pause for two (2) seconds, then press the same button again for two (2) seconds.
c. Release DOOR CODE button.
d. Press and hold the transmitter button for six (6) seconds to set Vacation Mode. The door code LED will stay lit while Vacation Mode is active.
e. To reset Vacation Mode, press the same button for two seconds.

Coding a Transmitter to enable AUX Output
Briefly press the DOOR CODE button two (2) times, then press it again and hold (the opener will beep three (3) times on the third press.
a. Press one of the four buttons on the transmitter for two (2) seconds, pause for two (2) seconds, then press the same button again for two (2) seconds.
b. Release the DOOR CODE button.
c. Press the transmitter button to test.

Setting the Transmitter to Operate PET (Pedestrian) Mode
The PET mode position (see Programming the Opener) must set prior to coding a transmitter.
a. Briefly press the DOOR CODE button three (3) times, then press it again and hold (the opener will beep four times on the fourth press.
b. Choose a transmitter button not already coded into the receiver. Press and hold this button for two (2) seconds, pause for two (2) seconds, then press the same button again for two (2) seconds and release.
c. Release the DOOR CODE button.
d. Press the transmitter button to test.

Coding a Transmitter to the Courtesy Light
The transmitter can be programmed to operate the courtesy light on the opener independently of the door moving.
a. Press and hold the DOOR CODE button four (4) times, then press it again and hold (the opener will beep five times on the five press).
b. Choose a transmitter button not already coded into the receiver. Press and hold this button for two (2) seconds, pause for two (2) seconds, then press the same button again for two (2) seconds and release.
c. Release the DOOR CODE button.
d. Press the transmitter button to test.