B&D – 25007 SDO-1 Rhino Manual Jun 2007 v1.2

Coding Transmitters

Setting the Transmitter to Operate Pet (Pedestrian) Mode

The opener can be programmed into a “Pet Mode” where the door opens partially to allow pets to enter/exit the garage:

a. Press the CODE SET button fi ve times, the CODE SET LED will illuminate and the courtesy light will flash quickly (twice per second) to indicate learning mode for Pet Mode is active.
b. Choose a transmitter button not already coded into the receiver. Press this button and the CODE SET LED will begin to flash.
c. Press the same transmitter button again. The CODE SET LED will illuminate for one second and then go out, and the courtesy light will also switch off. This indicates the code has been stored. This indicates the code has been stored (Fig. 37). 

To Erase Programmed Codes
If the CODE SET button is pressed and held for 6 seconds the CODE SET LED will blink rapidly for one second to indicate that all programmed codes have been erased. (Fig. 38).

Installation of the Wall Mounted Transmitter
Mount the transmitter in a convenient location, yet out of reach of children and at least 1.5m off the ground (Fig. 39).
Make sure the door is visible from this location. To set the transmitter codes refer to Step 17.1 on page 19.